Chimney Stack Removal in Ramsgate

We carry out chimney stack removal in Ramsgate for chimneys that are no longer used or are unsafe. We take the stack down, then close the gap in the roof and tile over it so it matches the rest.

Home > Chimney service > Chimney Stack Removal

Reasons to Remove a Chimney Stack

Many homes have chimneys that are no longer connected to a fire or boiler. They still need repointing, flashing repairs and pot checks, and they can cause leaks. Removing an unused stack takes away that upkeep and removes a common source of roof problems.

More Information

Sealing the Roof After the Stack Comes Down

Once the stack is taken down below the roof line, we cap the brickwork and fill the gap with new rafters or noggins where needed. We then fit membrane, battens and tiles to match the rest of the roof. Done properly, you should not be able to tell a chimney was there.

Shared Stacks and Party Walls

Many terraced and semi detached homes share a chimney stack with next door. If the stack is shared, the Party Wall Act may apply and your neighbour needs to be told before work starts. We explain what this means and how it affects the job before we begin.

About us

Chimney stack removal needs both chimney and roofing skills, as the job is only finished when the roof is sealed and tiled over. We handle both parts, so you do not need to bring in a second trade. Before any work on your home in Ramsgate, we check whether the stack is shared, how it is supported and whether any flues are still in use.

Emergency roof repairs available
Open 7am to 7pm, seven days a week
Roofs, chimneys and gutters handled by one team
Flat roofs in EPDM rubber, fibreglass or felt
Covering Ramsgate and the wider Thanet area

STILL NOT SURE?

Frequently Asked Questions

Do I need permission to remove a chimney stack in Ramsgate?

Removing a chimney stack above the roof line often does not need planning permission, but listed buildings and conservation areas have extra rules. If the stack is shared, the Party Wall Act may apply. Removing the chimney breast inside usually involves building regulations. We explain what applies in Ramsgate.

How long does chimney stack removal take?

Most chimney stack removals take a few days, including taking the stack down and tiling over the gap. The time depends on the size of the chimney, the access needed and the weather. We give you a clear timescale when we price the job.

Will removing my chimney stop damp?

If the damp is caused by water getting in through the chimney, removing the stack and sealing the roof should stop it. Any damp already in the chimney breast can take time to dry out. We check the cause of the damp before recommending removal.