Chimney Repointing in Ramsgate

We carry out chimney repointing in Ramsgate to replace soft, crumbling mortar with fresh mix. Good pointing keeps water out of the brickwork and stops frost from opening up the joints.

Home > Chimney service > Chimney Repointing

Why Chimney Pointing Fails

Mortar is softer than brick and wears away over time. Rain soaks into the joints, freezes in winter and pushes the mortar out. Once the joints open, water tracks into the brickwork and can run down inside the chimney. Left alone, the bricks themselves start to break down.

More Information

Raking Out the Old Mortar

Good repointing starts with removing the old mortar to a sufficient depth, usually around 15 to 20 mm. That gives the fresh mortar enough depth to grip the bricks and form a strong, weathertight joint. Pressing new mortar over the old without raking out does not last.

Matching the Mortar Mix

Old brickwork often needs a softer mortar mix than modern mixes to avoid damaging the bricks. We choose a mix that suits the age and type of brickwork and matches the original colour as closely as we can. This protects the chimney and keeps it looking right.

About us

Chimney repointing in Ramsgate is one of the most straightforward ways to stop water getting into the stack. We rake out the old mortar carefully, press fresh mix into each joint and finish it neatly. The work is done from a scaffold so we can reach every side of the chimney safely.

Emergency roof repairs available
Open 7am to 7pm, seven days a week
Roofs, chimneys and gutters handled by one team
Flat roofs in EPDM rubber, fibreglass or felt
Covering Ramsgate and the wider Thanet area

STILL NOT SURE?

Frequently Asked Questions

How do I know if my chimney needs repointing in Ramsgate?

Signs include mortar crumbling away from the joints, a line of dust or debris in the gutter below the chimney, and damp patches on the chimney breast inside the house. You may also see the joints have recessed more than the face of the bricks.

How long does chimney repointing last?

Yes. Repointing costs much less than rebuilding because the bricks stay in place and only the mortar is replaced. It is the right choice when the bricks are sound. If the stack is leaning or the bricks are badly damaged, rebuilding may be needed instead.

Can chimney repointing stop damp inside my home?

It can, if worn mortar is letting water into the stack. Repointing closes those gaps so rain runs off instead of soaking in. Damp can also come from failed flashing, cracked flaunching or an open pot, so we check all of these at the same time.